Waste Water Treatment

PPB Analyser Hygienic

Lorem ipsum dolor sit amet, consectetuer adipiscing elit, sed diam nonummy nibh euismod tincidunt ut laoreet dolore magna aliquam erat volutpat.


Our PPB Analyser Hygienic is a variant of the PPB DO meter for extremely low DO levels.


The PPB Hygienic can be ordered with ranges of 0-100 ppb or higher, and is also available in a dual-range model. It can be cleaned at 100°C. Its probe is designed to fit into a standard ND40 stainless steel dairy fitting with no difficult-to-clean dead spaces. The probe tip is made from a single piece of high-stability plastic and the membrane fits flush with a special gasket.

The PPB range of instruments are characterized by high accuracy, very fast response time, ease of use and maintenance, reasonable acquisition cost and very low cost of ownership.

The probe does NOT need regular service


Technical Information

Technical Information



Type: Self polarising (galvanic) membrane covered amperometric cell
Sample temperature: 0 to 40°C. Can be cleaned at temperatures up to 100°C.
Sample flow: Depends on oxygen content and temperature.
Sample pressure: Atmospheric to 6 bar.
Connections: Fits ND 40 dairy fittings – supplied with weld-on fitting.
Response Time (20°C): Upscale and downscale within range: To 90% of 100% step in less than 25 sec.
Stabilizing Time (20°C): After 1 minute calibration in air to 100 ppb in less than 1 minute.
After 1 minute calibration in air to 10 ppb in less than 5 minutes


Construction Cast metal enclosure with front panel with display and adjustments.
Dimensions & weight: 190 x 240 x 100 mm (WxHxD), approximately 3 kg.
Measuring range: 0-100 ppb or on request. (2-range version, 0-100 + 0-1000 ppb available).
Output: 4-20 mA, isolated from input. 0-20 mA on request.
Indicator: LCD display, digit height 12 mm.
Alarm: 1 high alarm. Potential free change over switch, max. 200 VA.
Encapsulation: IP 66.
Operating temperature: -20°C to +60°C
System Performance
Accuracy: Depends on calibration accuracy and method. Typically better than +/- 2 ppb when calibrated in air.
Repeatability: Typically better than +/- 0.5 ppb (or 2%).
Conformity: Linear.
Limit of Detection: Approx. 1 ppb.
Probe renovation: No regular maintenance necessary
N.B. The system has EMC (CE) approval
Contact us now to order or for more information on finding the best equipment for your needs.